![]() You May Like: How To Take Care Of My Pool Compare Free/Chlorine/Bromine, pH and total alkalinity pads to colour chart on label. To use, dip a strip into water and remove immediately, hold strip level for 15 seconds. Disperse over the water at the rate of 25ml per 1000 litres.ģ in 1 Test Strips: These test strips test the levels of free Chlorine/Bromine, pH & total alkalinity to keep you and your family safe. Once you have used antifoam, make sure you jet wash your filters. This Chemical will disperse foam build-up instantly. Add as instructed on the bottle.Īntifoam: Antifoam will eliminate foam which is built up from such products like sun cream, fake tan, oils and many cosmetics. Always aim for a pH level of between 7.4 and 7.6 pH. However, too high a pH level and the effectiveness of all chlorine sanitisers starts to decrease. pH plus can be used to raise the pH to a desirable level. PH Plus : Bathing water that is low in pH can be corrosive to pumps, heat exchangers and damage the tub lining. However, if the pH level drops too low then the water can start to degrade pumps and liners, so aim to keep the pH level between 7.4-7.6 pH. For the chlorine to remain effective, the pH level should be kept below 7.6. PH reducer can be added directly to the water to reduce the pH to a desirable level. If you notice that the control panel doesnt light up or it doesnt display any message, then you should check if the control panel is properly plugged in. When you turn on the hot tub, the control panel usually lights up or comes on. How do I know if my hot tub circuit board is bad?ĭon’t Miss: How To Get Metal Out Of Pool Water Hot Tub Control Panel Doesnt Light Up If its temperature is the same as the waters, the high limit switch must be replaced. If it is not submerged sufficiently, the temperature readings will be faulty.įinally, if the hot tubs temperature is still not regulated, the temperature of the high limit thermowell should be measured. ![]() Next, users should ensure that the thermostat probe is placed properly within the water. In order to test the switch, users should first ensure that the hot tubs thermostat levels have not been altered causing a change in temperature regulation. However, if water begins to climb beyond this temperature, it is likely the high limit switch is faulty. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |